-
ASTM D3330 – Peel Adhesion of Pressure-Sensitive Tape
ASTM D3330 specifies several test methods for determining the peel strength of Pressure Sensitive Adhesives (PSA).
There are 6 test methods called out in the specification.
Bilgi Almak İçin Lütfen Bizimle İletişime Geçiniz
-
ASTM D3759 – Standard Test Method for Tensile Strength and Elongation of Pressure-Sensitive Tapes
ASTM D3759 is used to characterize the breaking strength, elongation, and “F” value of PSA tapes. Tapes are commonly pulled in the tensile mode during application
and final usage.
Bilgi Almak İçin…
-
ASTM D3811 – Unwind Force of Pressure-Sensitive Tapes
ASTM D3811 characterizes a test for measuring the peak force needed to unwind a roll of pressure-sensitive adhesive (PSA) tape.
The procedure is intended to simulate unwind tape either with a human…
-
ASTM D395 – Rubber Property — Compression Set
ASTM D395 – This test method covers the testing of rubber intended for use in applications in which the rubber will be subjected to compressive stresses in air
or liquid media.
Bilgi Almak…
-
ASTM D412 – Vulcanized Rubber and Thermoplastic Elastomers—Tension
ASTM D412 – This test method covers procedures used to evaluate the tensile (tension) properties of vulcanized thermoset rubbers and thermoplastic elastomers.
These methods are not applicable to ebonite and similar hard,… -
ASTM D413 – Rubber Property—Adhesion to Flexible Substrate
ASTM D413 – This test method covers the determination of the adhesion strength between plies of fabric bonded with rubber or the adhesion of the rubber layer in
articles made from rubber…
-
ASTM D4595 – Tensile Properties of Geotextiles by the Wide-Width Strip Method
ASTM D4595 – This test method covers the measurement of tensile properties of geotextiles using a wide-width strip specimen tensile method.
This test method is applicable to most geotextiles that include woven…
-
ASTM D4833 – Index Puncture Resistance of Geomembranes and Related Products
ASTM D4833 – This test method is used to measure the index puncture resistance of geomembranes and related products.
The use of Test Method D 4833 may be inappropriate for testing some…
-
ASTM D575 – Rubber Properties in Compression
ASTM D575 – This test method cover two test procedures for determining the compression-deflection characteristics of rubber compounds other than
those usually classified as hard rubber and sponge rubber.
Bilgi Almak İçin Lütfen…
-
ASTM D6195 – Standard Test Methods for Loop Tack
ASTM D6195 specifies a few procedures to measure quick stick adhesive strength.
This test is different from a peel test because the tape is not given enough time or pressure to fully…
-
ASTM D624 – Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
ASTM D624 – Elastomer Tear Strength Test Fixture
ASTM D624 – This test method describes procedures for measuring a property of conventional vulcanized rubber and thermoplastic elastomers called tear strength.
Vulcanized rubber and…
-
ASTM D638 – Tensile Properties of Plastics
ASTM D638 – This test method covers the determination of the tensile properties of unreinforced and reinforced plastics in the form of standard dumbbell-shaped test
specimens when tested under defined conditions…
- TR | EN
- Tel : 0 (312) 394 28 68
- WhatsApp: 0546 437 05 06