-
ASTM D695 – Compressive Properties of Rigid Plastics
ASTM D695 – describes a test method for rigid plastics in compression. There are a few variations in the test, depending on the size of the sample being used.
The test can be…
-
ASTM D732 – Shear Strength of Plastics by Punch Tool
ASTM D732 – Shear Punch Tool
ASTM D732 – This test method covers the procedure for determining the shear strength of plastics in the form of sheets, plates, and molded shapes in thicknesses…
-
ASTM D790 – Flexural Properties of Unreinforced and Reinforced Plastics
ASTM D790 – This test method is used to determine the flexural properties of unreinforced and reinforced plastics, including high modulus composites and electrical insulating
materials utilizing a three-point loading system…
-
ASTM D903 – Peel or Stripping Strength of Adhesive Bonds
ASTM D903 – This test method covers the determination of the comparative peel or stripping characteristics of adhesive bonds when tested on standard-sized specimens
and under defined conditions of pretreatment, temperature,…
-
ASTM E290 – Standard Test Methods for Bend Testing of Material for Ductility
ASTM E290 – This test method covers bend testing for ductility of materials.
Included in the procedures are four conditions of constraint on the bent portion of the specimen; a guided-bend test… -
ASTM E643 – Standard Test Method for Ball Punch Deformation of Metallic Sheet Material
ASTM E643 – This test method covers the procedure for conducting the ball punch deformation test for metallic sheet materials intended for forming applications.
The test applies to specimens with thicknesses between… -
ASTM E8 – Tension Testing of Metallic Materials
ASTM E8 – This test method covers the tension testing of metallic materials in any form at room temperature, specifically, the methods of determination of
yield strength, yield point elongation, tensile strength,… -
ASTM F1554 – Anchor Bolts, Steel, 36, 55, and 105-ksi Yield Strength
ASTM F1554 – This specification covers straight, bent, headed, and headless anchor bolts (also known as anchor rods) made of carbon, medium carbon boron,
alloy, or high-strength low- alloy steel.Bilgi Almak İçin…
-
ASTM F3125 – High Strength Structural Bolts and Assemblies, Steel and Alloy Steel, Heat Treated, Inch Dimensions 120 ksi and 150 ksi Minimum Tensile Strength, and Metric Dimensions 830 MPa and 1040 MPa Minimum Tensile Strength
ASTM F3125 – This specification covers chemical, physical and mechanical requirements for quenched and tempered bolts manufactured from steel and
alloy steel, in inch and metric dimensions, in two strength grades, two… -
ASTM F88 – Standard Test Method for Seal Strength of Flexible Barrier Materials
ASTM F88 – This test method covers the measurement of the strength of seals in flexible barrier materials. The test may be conducted on seals between a flexible
material and a… -
ISO 527-2 Tensile Testing For Plastics
ISO 527-2 specifies the test conditions for determining the tensile properties of moulding and extrusion plastics, based upon the general principles given in ISO 527‑1.
Bilgi Almak İçin Lütfen Bizimle İletişime Geçiniz
- TR | EN
- Tel : 0 (312) 394 28 68
- WhatsApp: 0546 437 05 06